Replacement

1. If the compressor is marginally operable, run the engine at idle speed and let the air conditioning work a few minutes, then shut the engine off and disconnect the battery negative cable.

2. Discharge the refrigerant (see page 22-19).

3. Remove the power steering pump (see section 17).

4. Remove the two bolts and disconnect the suction line and discharge line from the compressor.

CAUTION: Cap the open fittings immediately to keep moisture out of the system.

5. Loosen the adjusting pulley nut and adjusting bolt, and remove the compressor belt.

Remove the two left engine mount bolts, and pass the belt through the gap between the body and left engine mount.

6. Disconnect the compressor clutch 1 P connector.

7. Remove the four compressor mounting bolts and compressor.