Мануалы автомобилей Хонда

ВНИМАНИЕ! График работы на майских праздниках: Офис в Москве: 9 мая ВЫХОДНОЙ! Офис в СПБ: 1 мая, 9 мая - ВЫХОДНОЙ!

6. Pull out the outer handle.

Pry the outer handle rod out of its joint using diagonal cutters, then remove the outer handle.

NOTE:

To ease reassembly, note location (A of the outer handle rod on the joint before disconnecting it.

Take care not to bend the outer handle rod.

Use a shop towel to protect the opening in the door.

7. Installation is the reverse of the removal procedure.

NOTE:

Make sure the outer handle rod is connected properly.

Make sure the door locks and opens properly.

Latch Replacement

NOTE: Raise the glass fully.

1. Remove:

Door panel (see page 20-16)

Plastic cover (see page 20-16)

Outer handle (see page 20-18)

2. Disconnect the inner handle rod and lock rod from the latch, then remove them.

3. Disconnect the connector, then remove the latch through the outer handle opening.

4. Installation is the reverse of the removal procedure.

NOTE:

Make sure the inner handle rod, lock rod and connector are connected properly.

Make sure the door locks and opens properly.