ВНИМАНИЕ! График работы на майских праздниках: Офис в Москве: 9 мая ВЫХОДНОЙ! Офис в СПБ: 1 мая, 9 мая - ВЫХОДНОЙ!

Transmission Assembly

Removal

A WARNING

Make sure jacks and safety stands are placed properly, see section 1).

Apply parking brake and block rear wheels so car will not roll off stands and fall on you while working under it.

CAUTION: Use fender covers to avoid damaging painted surfaces.

1. Disconnect the negative (-) cable first, then the positive (+) cable from the battery.

2. Remove the intake air tube, intake air duct and air cleaner housing assembly.

3. Drain transmission oil (see page 13-3).

4. Disconnect the starter motor cables and transmission ground wire.

5. Remove the wire harness clamps.

6. Disconnect the back-up light switch connector and vehicle speed sensor (VSS) connector.

7. Remove the clutch pipe bracket, clutch pipe clamp, and slave cylinder.

CAUTION:

Do not operate the clutch pedal once the slave cylinder has been removed.

Take care not to bend the clutch pipe.