ВНИМАНИЕ! График работы на майских праздниках: Офис в Москве: 9 мая ВЫХОДНОЙ!
Офис в СПБ: 1 мая, 9 мая - ВЫХОДНОЙ!
Filter
Replacement
CAUTION: After the engine has been run, the exhaust pipes will be hot; be careful when working around the exhaust manifold.
1. Remove the oil filter with the special oil filter socket.
2. Inspect the threads and rubber seal on the new filter.
Wipe off seat on engine block, then apply a light coat of oil to the filter rubber seal.
NOTE: Use only filters with a built-in bypass system.
3. Install the oil filter by hand.
4. After the rubber seal is seated, tighten the oil filter clockwise with the special tool.
Tighten: 7/8 turn clockwise.
Tightening torque: 22 N•m (2.2 kg-m, 16 Ib-ft)
CAUTION: Installation using other than the above procedure could result in serious engine defects due to oil leakage.