Inspection Using Special Tools (D16Z6 engine)

CAUTION:
•   Before using the Valve Inspection Tool, make sure that the air pressure gauge on the air compressor indicates over 250 kPa (2.5 kg/cm2, 36 psi).
•   Inspection the valve clearance before rocker arm inspection.
•   Cover the timing belt with a shop towel to protect the belt.
•   Check the intake mid rocker arm of each cylinder at TDC.

1. Remove the cylinder head cover.

2. Plug the relief hole with the special tool (Air Stopper).

3. Remove the sealing bolt and washer from the inspection hole and connect the Valve Inspection Tool.