Cylinder Head

Installation

Install the cylinder head in the reverse order of removal:

NOTE:
•   Always use a new head gasket.
•   Cylinder head and engine block surface must be clean.
•   Turn the crankshaft so that No. 1 piston is at TDC (page 6-63).
1. Install the intake manifold and tighten the nuts in a criss-cross pattern in 2 or 3 steps, beginning with the inner nuts.

2. Install the exhaust manifold and tighten the nuts in a criss-cross pattern in 2 or 3 steps, beginning with the inner nut.


3. Install the catalytic converter on the exhaust manifold, then install the exhaust manifold assembly.