Recirculation Control Motor

Test

1. Connect the battery positive terminal to the tD terminal of the recirculation control motor connector and negative to the 2® and ® terminals; the recirculation control motor should move smoothly.

2. Disconnect the battery negative terminal from (2 or 0; the recirculation control motor should stop at FRESH or REC.

CAUTION: Never connect the battery in the opposite direction.
NOTE:
•   If the recirculation control motor does not run when shorting the first terminal, short that terminal again after shorting the other terminals. The recirculation control motor is normal if it runs when shorting the first terminal again.
•   Don't cycle the recirculation control motor for a long time.
• After adjusting the recirculation control rod, check the recirculation motor on FRESH or REC for two minutes to make sure It operates properly.

Replacement

1. Disconnect the 4P connector from the recirculation control motor and remove the wire harness holder.

2. Remove the screws (3), recirculation control motor and flange collar.

3. Installation is the reverse of the removal procedure After installation, make sure the recirculation con trol motor operates smoothly.