Replacement
SRS wire harnesses are routed near the dashboard and steering column.
CAUTION:
• All SRS electrical wiring harnesses are covered with yellow outer insulation.
• Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-273).
• Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.
1. To remove the dashboard, first remove the:
• Front seats (page 20-60)
• Center lower cover (page 20-72)
• Dashboard lower cover (page 20-74)
• Glove box (page 20-73)
AWARNMNG To avoid accidental deployment and possible injury always install the protective short connector on the inflator connector when the harness is disconnected.
2. Lower the steering column (see Section 17).
NOTE: To prevent damage to the steering column, wrap it with a shop towel.
3. Remove the access panel on each end and the upper air vent.
4. Disconnect the connectors and heater control cable.
5. Remove the 6 mounting bolts, then lift and remove the dashboard.
NOTE:
• Use protective tape on the bottom of the front pillar trim.
• Take care not to scratch the dashboard.
• When prying with a flat tip screwdriver, wrap it with protective tape to prevent damage.