Rear Edge Closing Adjustment

Open the glass about a foot, then close it to check where rear edge begins to rise. If it rises too soon and seats too tightly against the roof panel, or too late and does not seat tightly enough, adjust it.

1. Remove the sliding glass.

2. Remove the moonroof motor (page 20-44).

3. Align the tilt-up position of the lifter on each side.

4. Check that the alignment left and right, then install the moonroof motor.

NOTE: If necessary, check the tilt-up position of moonroof motor (idler cam) as shown.

Glass and Sunshade Replacement

1. Open the sunshade.

2. Tilt-up the sliding glass.

3. Remove the glass mounting screws, then remove sliding glass from the bracket.

4. Remove the screws and lift the sunshade rails.

5. Silde the sunshade forward, then remove the sunshade.

6. Install the sunshade and glass in the reverse order of the removal procedure.

7. Check for water and air leaks.

NOTE: Do not use high pressure water.