Front Door

Door Panel/Plastic Cover Replacement

1. If applicable, remove the regulator handle by pulling the clip out with a wire hook.

2. Remove the mounting screw, then pull the inside door handle out half-way and disconnect the handle rod and connector.


3D: Remove the mounting screw, then remove the trim while pulling the handle.
3. Remove the mounting screw, then remove the armrest pocket.


NOTE: Remove the panel with as little bending as oossible to avoid creasing or breaking it.

4. Remove the clips attaching the door panel (See trim pad remover). Remove the door panel by pulling it upward.
If applicable, disconnect the power window connector