Windshield

Removal

CAUTION:
•   Wear gloves to remove and install the glass.
•   Use seat covers to avoid damaging any surfaces.

1. To remove the windshield, first remove the:
•   Rearview mirror (page 20-25)
•   Sun visors, center visor (page 20-57)
•   Front pillar trim (page 20-58)
•   Front wipers and air scoop (see Section 23)

2. Detach the clips from the retainers, then remove the side molding as shown.

NOTE: If necessary, replace any damaged clips.

3. Peel off the upper molding.

NOTE: When the upper molding removal is difficult, cut the upper rubber portion ® off the molding, then cut the side rubber portion.

4. Pull down the front of headliner, (page 20-57).

CAUTION: Take care not to bend the headliner excessively.

5. Remove the other retainers from the body.

6. Apply protective tape along the edge of the dashboard and body next to the glass as shown. Using an awl, make a hole through the windshield adhesive from inside the car. Push piano wire throught the hole and wrap each end around a piece of wood.