Glass/Regulator Replacement

1. Remove:
•   Door panel (page 20-13)
•   Plastic cover (page 20-14)
•   Corner sash trim (page 20-19)
2. Remove the rear channel mounting nut and bolt.
3. Carefully move the window until you can see its mounting bolts, then remove the bolts. Carefully pull the glass out through the window slot.

NOTE:
•   Take care not to drop the glass inside the door.
•   Take care not to damage the location (A of the glass run channel.

4. Peel the glass run channel out of the channel, then remove the rear channel.

NOTE: After installing, make sure the glass run channel is not twisted.

NOTE: To install, fit the glass run channel into the rear channel as shown.

5. Remove the 2 mounting bolts. Loosen the upper mounting bolt and 3 motor bolts. Disconnect the connector (Power window model). Remove the regulator assembly through the center hole in the door.