Outside Door Handle Replacement
NOTE: Raise the window fully.
1. Remove:
• Door panel (page 20-13)
• Plastic cover (page 20-14)
• Corner sash trim (page 20-19)
2. Loosen the mounting nut and remove the mounting bolt, then move the rear channel forward.
3. Disconnect the handle rod and lock rod from the latch.
NOTE: Take care not to bend the rods.
4. Remove the mounting screws, then slide the latch assembly down until you can see the outside door handle mounting bolt (page 20-16).
5. Remove the mounting bolts, then pull out the outside door handle.
Pry the door handle latch rod out of its joint using a flat tip screwdriver.
NOTE:
• Use protective tape around the outside door handle to prevent damage.
• To ease reassembly, note the location OA of the rod on the joint before disconnecting it.
6. Installation is the reverse of the removal procedure.