Electronic Components

Control Unit Replacement

1. Remove the right trunk side trim panel.
2. Disconnect the control unit connectors.

3. Remove the control unit attaching bolts, then remove the control unit.

Relay Inspection

1. Remove the fail-safe relay and motor relay from the under-hood ABS fuse/relay box (Location: page 19-54).

2. Check for continuity between the terminals C and D.
There should be continuity.
3. Check for continuity between the terminals A and B.
There should be continuity when the battery is connected between the terminals C and D.
There should be no continuity when the battery is disconnected.