Front Brake Pads

Inspection/Replacement

WARNING
•   Never use an air hose or dry brush to clean brake assemblies.
•   Use an OSHA-approved vacuum cleaner, to avoid breathing brake dust.
1. Loosen the front wheel lug nuts slightly, then raise the car and support on safety stands.
2. Remove the caliper bolt and pivot the caliper up out of the way.

3. If the brake pad thickness is less than service limit at step 5, replace the front pads as a set.

4. Remove the pad shims, pad retainers and pads.
5. Using vernier calipers, measure the thickness of each brake pad lining.

Brake Pad Thickness:
Standard:   Except EX:   9.0 mm (0.35 in)
EX with ABS:   11.0 mm (0.43 in)
EX without ABS: 10.0 mm (0.39 in) Service Limit: 1.6 mm (0.06 in)

NOTE: Measurement does not include pad backing plate thickness.

6. Clean the caliper thoroughly; remove any rust, and check for grooves or cracks.

7. Install the pad retainers.