Pedal Height

Adjustment

1. Disconnect the brake light switch connector, loosen the brake tight switch locknut and back off the brake light switch until it is no longer touching the brake pedal.

A: Pedal Play
1-5 mm (1/16-13/64 in)
B: Standard Pedal Height MT: 160 mm (6.30 in) AT: 165 mm (6.50 in) (with floor mat removed)

2. Loosen the pushrod locknut and screw the pushrod in or out with pliers until the standard pedal height from the floor is reached. After adjustment, tighten the locknut firmly.

3. Screw in the brake light switch until its plunger is fully depressed (threaded end touching the pad on the pedal arm). Then back off the switch 1 /4 turn to make 0.3 mm (0.012 in) of clearance between the threaded end and pad. Tighten the locknut firmly. Connect the brake light switch connector.
CAUTION: Check that the brake lights go off when the pedal is released.
Brake Pedal Play Inspection:
Stop the engine and inspect the play by pushing the pedal by hand.

Brake Pedal Play: 1-5 mm (1/16-13/64 in)

NOTE: Do not adjust the pedal height with the pushrod depressed.

CAUTION: If the pedal free play is out of specification, brake drag may occur.