Rear Brake Shoes

Reassembly

1. Apply Brake Cylinder Grease (P/N: 08733-B020E) or equivalent rubber grease to the sliding surface of the pivot pin, and insert the pin into the brake shoe.

2. Install the parking brake lever and wave washer on the pivot pin and secure with U-clip.

NOTE: Pinch the U-clip securely to prevent the pivot pin from coming out of the brake shoe.

3. Connect the parking brake cable to the parking brake lever.

4. Apply grease on each sliding surface.
CAUTION: Contaminated brake linings reduce stopping ability. Keep grease or oil off the brake linings. Wipe any excess grease off the parts.

• Apply Brake Cylinder Grease (P/N: 08733B020E) or equivalent rubber grease to the sliding surfaces as shown.

•   Apply Molykote 44MA to the brake shoe ends and opposite edges of the shoes as shown.

5. Clean the threaded portions of clevises A and B. Coat the threads of the clevises with grease. To shorten the clevises, turn the adjuster bolt.
6. Hook the adjuster spring to the adjuster lever first, then to the brake shoe.
7. Install the clevises and upper return spring noting the installation direction.
NOTE: Be careful not to damage the wheel cylinder dust covers.
8. Install the lower return spring.
9. Install the tension pins and retaining springs.