Rear Damper

Disassembly

1 . Compress the damper spring with the spring compressor according to the manufacturer's instructions.
CAUTION: Do not compress the spring more than necessary to remove the self-locking nut.
2. Remove the self-locking nut from the damper assembly.

3. Remove the spring compressor and disassembly the damper as shown on page 18-35.

Inspection

1. Reassemble all parts, except the spring.
2. Push on the damper assembly as shown.

3. Check for smooth operation through a full stroke, both compression and extension.

NOTE: The damper should move smoothly.
If it does not (no compression or no extension), then gas is leaking, and the damper should be replaced.

4. Check for oil leaks, abnormal noises or binding during these tests.