ВНИМАНИЕ! График работы на майских праздниках: Офис в Москве: 9 мая ВЫХОДНОЙ!
Офис в СПБ: 1 мая, 9 мая - ВЫХОДНОЙ!
Upper Arm Bushing Replacement
1. Remove the front wheels.
2. Rock the upper ball joint front-to-back.
3. Replace the upper arm bushings as follows if there is any play.
4. Remove the self-locking nuts, upper arm bolts and upper arm anchor bolts.
5. Place each upper arm anchor bolt in a vise and drive out the upper arm bushings.
6. Drive the new upper arm bushings into the upper arm anchor bolts.
NOTE: Center the bushing so that 1 1 mm (0.4 in) protrudes from each side of the anchor bolt as shown.
7. Install the upper arm bolts and tighten the selflocking nuts.
NOTE: Align the upper arm anchor bolt with the mark on the upper arm.
8. After installation, check the camber (page 18-4).