Pump Assembly

1. Coat the lip of the new oil seal with steering grease (Honda P/N 08733-BO70E).
2. Install the new oil seal in the pump housing by hand, then install the pump seal spacer.
3. Install the pump driver shaft assembly with the special tool.

4. Install the 38 mm circlip with its tapered side facing out.

5. Coat the side plate grooves with power steering fluid, then position the 16.8 x 1.9 mm and 54 x 1.9 mm O-rings on the side plate.

6. Install the preload spring in the pump housing.

7. Set the 4.5 x 49.8 mm roller in the 4.5 mm hole in the pump housing.

8. Set the side plate over the roller and install it on the pump housing.

9. Set the 5 x 26.8 mm roller in the 5 mm hole in the side plate.

10. Assemble pump rotor to the drive shaft with the "o" mark on the rotor facing upward.

11 . Set the 10 vanes in the grooves in the rotor.

NOTE: Be sure that the round end of the vanes is in contact with the sliding surface of the cam ring.