Steering Column

Removal

CAUTION:
•   All SRS electrical wiring harnesses are covered with yellow outer insulation.
•   When disconnecting the SRS wire harness, install the short connector on the airbag, then disconnect the wire harness (see page 23-297).
•   Replace the entire affected SRS harness assembly if there is an open circuit or damage to the wiring.

1. Remove the airbag assembly and steering wheel (page 17-46).

2. Remove the lower cover.

3. Remove the driver's knee bolster.

4. Remove the upper column and lower column covers.

5. Disconnect the SRS wire harness and cable reel wire harness at the underside of the column bracket, then remove the cable reel assembly.