Steering Wheel (With SRS)

Removal

Airbag Removal
CAUTION:
•   All SRS electrical wiring harnesses are covered with yellow outer insulation.
•   When disconnecting the SRS wire harness, install the short connector on the airbag, then disconnect the wire harness (see page 23-297).
•   Replace the entire affected SRS harness assembly if there is an open circuit or damage to the wiring.
1. Disconnect the negative and positive cable from the battery.
2. Remove the access panel from the steering wheellower cover, then remove the short connector.
3. Disconnect the connector between the airbag and cable reel.

4. Connect the short connector to the airbag side of the connector.

5. Remove the lid B and cruise control set/resume switch cover.
6. Remove the TORX° T30 bit bolt and 6 mm screw, then remove the airbag assembly.