Installation

1. Install the outboard joint in the knuckle, then loosely install the new spindle nut.

2. Install the inboard end of the driveshaft into the differential.

CAUTION: Make sure the driveshaft locks in the differntial side gear groove, and the CV joint subaxle bottoms in the differential.

3. Install the damper fork over the driveshaft and onto the lower arm. Install the damper in the damper fork so the aligning tab is aligned with the slot in the damper fork.

4. Loosely install the damper pinch bolt and the new damper fork nut.

NOTE: The bolts and nuts should be tightened with the vehicle's weight on the damper.

5. Install the knuckle on the lower arm, then tighten the castle nut and install new cotter pin.

CAUTION:
•   Be careful not to damage the ball joint boot.
•   Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the pin hole. Do not align the nut by loosening.