Driveshafts

Disassembly/Inspection

NOTE:
• Mark the rollers and roller grooves during disassembly to ensure proper positioning during reassembly.
• Before disassembly, mark the spider and driveshaft so they can be reinstalled in their original positions.
• The inboard joint must be removed to replace the boots.
•   If the boot band is the welded type, cut off as shown.
CAUTION: Take care not to damage the boots.
Thoroughly pack the inboard joint and both joint boots with joint grease included in the new driveshaft set.

Grease Quantity:

Inboard Joint	120-130 g (4.2-4.6 oz)
Outboard Joint	90-100 g (3.2-3.5 oz)