Sub-shaft

Disassembly/Inspection/Reassembly

NOTE:
•   Lubricate all parts with ATF before reassembly.
•   Install thrust needle bearings with unrolled edge of bearing retainer facing washer.
•   Inspect thrust needle and needle bearings for galling and rough movement.
•   Before installing the O-rings, wrap the shaft splines with tape to prevent damaging the O-rings.
1. Remove the oil guide cap.
2. Remove the sub-shaft, 1 st-hold clutch assembly and 4th gear assembly. 3. Assemble the sub-shaft in the reverse order of removal.