Inspection

•   Clearance Measurement

NOTE: Lubricate all parts with ATF during assembly.
1. Remove the countershaft bearing from the transmission housing (see page 14-107).
2. Assemble the parts below on the countershaft.

NOTE: Do not assemble the O-rings while inspecting.

3. Torque the countershaft locknut to 30 N•m (3.0
kg-m, 22 lb-ft).

4. Measure the clearance between the 4th gear and the reverse selector hub with a feeler gauge.

NOTE: Take measurements in at least three places and take the average as the actual clearance.

STANDARD: 0.05-0.13 mm (0.002-0.005 in)