ВНИМАНИЕ! График работы на майских праздниках: Офис в Москве: 9 мая ВЫХОДНОЙ!
Офис в СПБ: 1 мая, 9 мая - ВЫХОДНОЙ!
Mainshaft
Inspection
• Clearance Measurement
NOTE: Lubricate all parts with ATF during assembly.
1. Remove the mainshaft bearing from the transmission housing (see page 14-107).
2. Assemble the parts below on the mainshaft.
NOTE: Do not assemble the 0-rings while inspecting.
3. Torque the mainshaft locknut to 30 N•m (3.0 kg-m,
22 lb-ft).
NOTE: Mainshaft locknut has left-hand threads.
4. Hold the 2nd gear against the 2nd clutch. Measure the clearance between the 2nd gear and the 3rd gear with a feeler gauge.
NOTE: Take measurements in at least three places and take the average as the actual clearance.
STANDARD: 0.05-0.13 mm (0.002-0.005 in)