Valve Caps

Description

•   Caps with one projected tip and one flat end are installed with the flat end toward the spring.
•   Caps with a projected tip on each end are installed with the smaller tip toward the spring. The small tip is a spring guide.

• Caps with one projected tip and hollow end are installed with the tip toward the spring. The tip is a spring guide.


•   Caps with hollow ends are installed with the hollow
end away from the spring.
•   Caps with notched ends are installed with the notch
toward the spring.
•   Caps with flat ends and a hole through the center are
installed with the smaller hole toward the spring.

•   Caps with flat ends and a groove around cap are installed with the groove side toward the spring.

Toward outside of valve body.