Shift Cable

Removal/Installation

CAUTION:
•   All SRS electrical wiring harnesses are covered with yellow outer insulation.
• Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-273).
• Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.

AWARNING Make sure lifts are placed properly (see page 1-10 thru 1-12).

1. Remove the center console (see page 20-72).

2. Shift to l N f position, then remove the lock pin from the cable adjuster.

3. Remove the shift cable bracket.

4. Remove the shift cable holder. 5. Remove the shift cable cover.
6. Remove the control lever from the control shaft, then remove the shift cable. Take care not to bend the cable when removing/installing it.

7. Install the shift cable in the reverse order of removal.

8. Check the cable adjustment on reassembly, on page 14-125.