Transmission

Reassembly

14. Install the splash shield.

15. Install a new set ring on the end of the each driveshaft.

16. Install the right and left driveshafts (see Section 16).

NOTE: Turn the right and left steering knuckle fully outward, and slide each driveshaft into the differential until you feel its spring clip engage the side gear.

17. Install the damper fork, then install the ball joint to the lower arm with a new castle nuts and cotter pins.

18. Connect the speedometer sensor connector.

19. Connect the lock-up control solenoid connector, and clamp the harness on the lock-up control solenoid connector stay.