Parking Brake Stopper

Inspection/Adjustment

1. Set the parking brake lever in the Park position.

2. Measure the distance between the face of the parking brake pawl shaft and face of the parking brake lever roller pin as shown.

STANDARD: 67.25-68.25 mm (2.65-2.69 in)

3. If the measurement is out of tolerance, select and install the appropriate parking brake stopper from the table below.

I PARKING BRAKE STOPPER

Mark	Part Number	Li	L2
1	24537-PA9-003	11.00 mm (0.433 in)	11.00 mm (0.433 in)
2	24538-PA9-003	10.80 mm (0.425 in)	10.65 mm (0.419 in)
3	24539-PA9-003	10.60 mm (0.417 in)	10.30 mm (0.406 in)

4. After replacing the parking brake stopper, make sure the distance is within torelance.