Transmission Assembly

Removal

A WARNING
• Make sure jacks and safety stands are placed properly,and hoist brackets are attached to correct position on the engine.
• Apply parking brake and block rear wheels so car will not roll off stands and fall on you while working under it.
CAUTION: Use fender covers to avoid damaging painted surfaces.
1. Disconnect the battery negative(-) and positive (+) cables from the battery.

2. Remove the resonator, air intake hose, and air cleaner case.

3. Disconnect the starter cables and transmission ground wire.

4. Remove the engine wire harness clamp.

5. Disconnect the back-up light switch and speed sensor connectors.

6. Remove the clutch pipe bracket and slave cylinder.

NOTE: Do not operate the clutch pedal once the slave cylinder has been removed.