ВНИМАНИЕ! График работы на майских праздниках: Офис в Москве: 9 мая ВЫХОДНОЙ!
Офис в СПБ: 1 мая, 9 мая - ВЫХОДНОЙ!
Synchro Sleeve, Svnchro Hub
Inspection
1. Inspect gear teeth on all synchro hubs and sleevesfor rounded off corners, which indicate wear.
2. Install each hub in its mating sleeve and check for freedom of movement.
Installation
Each synchro sleeve has three sets of longer teeth (120 degrees apart) that must be matched with the three sets of deeper grooves in the hub when assembled.
NOTE: Installing the synchro sleeve with its longer teeth in the 1 st/2nd synchro hub slots will damage the spring ring.