Countershaft Assembly

Reassembly

4. Support the countershaft on a steel block as shown and install 3rd gear using the special tools and a press.

5. Install 4th gear using the special tools and a press as shown.

6. Install 5th gear using a press as shown.

7. Install the bearings using a press as shown.

8. Install the spring washer, tighten the locknut, then stake the locknut tab into groove.

LOCKNUT 110-0-110 N•m
(11.0-0-11.0 kg-m, 80-0-80 Ib-ft)