Pressure Plate

Removal/Inspection

1. Inspect the fingers of the diaphragm spring for wear at the release bearing contact area.

2. Check the diaphragm spring fingers for height using the special tools and a feeler gauge.

Standard (New): 0.8 mm (0.03 in) Min. Service Limit:   1.0 mm (0.04 in) Max.

3. Install the ring gear holder, handle and Clutch Alignment Shaft.

4. To prevent warping, unscrew the pressure plate mounting bolts two turns at a time in a criss-cross pattern, then remove the pressure plate.

5. Inspect the pressure plate surface for wear, cracks, or burning.

6. Inspect the fingers of the diaphragm spring for wear at the release bearing contact area.

7. Inspect for warpage using a straight edge and feeler gauge. Measure across the pressure plate.

Standard (New): 0.03 mm (0.001 in) Min. Service Limit:   0.15 mm (0.006 in)