ВНИМАНИЕ! График работы на майских праздниках: Офис в Москве: 9 мая ВЫХОДНОЙ!
Офис в СПБ: 1 мая, 9 мая - ВЫХОДНОЙ!
Fuel Supply System
System Description
The fuel supply system consists of a fuel tank, in-tank high pressure fuel pump, main relay, fuel filter, pressure regulator, injectors, and fuel delivery and return lines. This system delivers pressure-regulated fuel to the injectors and cuts the fuel delivery when the engine is not running.
Fuel Pressure
Relieving
Ilk V AIMIN(;
• Do not smoke while working on the fuel system. Keep open flames or sparks away from the work area.
• Be sure to relieve fuel pressure while the engine is Off.
NOTE: Before disconnecting fuel pipes or hoses, release pressure from the system by loosening the 6
mm service bolt on top of the fuel filter.
1. Disconnect the battery negative cable from the battery negative terminal.
2. Remove fuel filler cap.
3. Use a box end wrench on the 6 mm service bolt at the fuel filter, while holding the special banjo bolt
with another wrench.
4. Place a rag or shop towel over the 6 mm service bolt.
5. Slowly loosen the 6 mm service bolt one complete turn.
NOTE:
• A fuel pressure gauge can be attached at the 6 mm service bolt hole.
• Always replace the washer between the service bolt and the special banjo bolt, whenever the service bolt is loosened.
• Replace all washers whenever the bolts are removed.