Trunk Lid
Replacement/Adjustment
NOTE: An assistant is helpful when removing the trunk lid.
ALIGNMENT:
• Loosen the trunk lid mounting bolts, then adjust the trunk lid fore and aft, and right and left as necessary to equalize the gap between the trunk lid and the body.
• The hinges can be adjusted up and down by using the elongated holes.
• Adjust the trunk lid fit to the trunk lid opening by moving the striker.
• Turn the edge cushions as necessary, to make the trunk lid fit flush with the body at front and side edges.
• Use shims as necessary, to make the trunk lid fit flush with the body at the rear edge.
Installation is the reverse of the removal procedure.
NOTE:
• Make sure the connector is connected properly.
• Adjust the trunk lid alignment.