Dashboard

Component Removal/Installation


SRS wire harnesses are routed near the dashboard and steering column.

CAUTION:
•   All SRS electrical wiring harnesses are covered with yellow outer insulation.
•   Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-273).
• Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.

NOTE:
•   Do not drop the screws inside the dashboard.
•   Take care not to bend the cable.
•   When prying with a flat tip screwdriver, wrap it with protective tape to prevent damage.
Принимаем:
Мы в социальных сетях:
Напишите нам:
Наши телефоны:
Наши реквизиты:
ООО "ПартсРу"
ИНН 7713747944, КПП 774301001
ОГРН 1127746372401

Политика конфиденциальности
2024, HondaWorld.
Все права защищены
Карта сайта