3. Pull out the retainer clip, then remove the lock cylinder.
4. Installation is the reverse of the removal procedure.
Door Latch Replacement
NOTE: Raise the window fully.
1. Remove:
• Door panel (page 20-4)
• Plastic cover (page 20-5)
• Rear channel (page 20-9)
2. Pry the door handle latch rod and lock rod out of its joint using a flat tip screwdriver. Disconnect the connectors from the door. Remove the mounting screws, then remove the latch assembly through the hole in the door.
NOTE:
• Take care not to bend the rods.
• To ease reassembly, note the location (& of the
rod on the joint before disconnecting it.