Rear Replacement
CAUTION: Check the seat belts for damage and replace them if necessary. Be careful not to damage them during removal and installation.
1. Remove:
• Rear seat (pages 20-63, 64) • Quarter trim panel (3D) (page 20-58)
• Rear shelf (4D) (page 20-59) • Rear pillar trim panel (pages 20-58, 59)
2. Remove the upper anchor bolt, lower anchor bolt and retractor bolt with a 17 mm socket or box-end wrench.
3. Check that the retractor locking mechanism function as described on page 20-68.
4. Installation is the reverse of the removal procedure.
NOTE:
• Before attaching the rear pillar trim panel and rear seat, make sure there are no twists in the belt.
• On reassembly, replace the upper anchor bolt (*) and use liquid thread lock.