Front Door

Plastic Cover Replacement

• Apply adhesive along the edge where necessary to maintain a continuous seal and prevent air/water leaks.

• Before tightening the door panel mounting screws, make sure the wire harnesses are not pinched.

Outside Door Handle Replacement

NOTE: Raise the window fully.

1. Remove:
•   Door panel (page 20-4)
•   Plastic cover (page 20-5)
2. Pry the door handle latch rod and lock rod out of their joints using a flat tip screwdriver. Remove the mounting bolts, then remove the outside door handle.


NOTE: Use protective tape around the outside door handle to prevent damage.

•   To ease reassembly, note the location ®A of the rod on the joint before disconnecting it.