Slide Switch Adjustment (Fully Closed Position)

1. Remove the headliner (page 20-57).

2. Using the moonroof wrench, close the glass fully.

NOTE: Check the sliding glass fit to the roof panel (page 20-49). 3. Using the spanner, loosen the switch plate mounting bolts. 4. Adjust position of the slide switch (switch cam) as shown.

5. Check the operation of the sliding glass (from tilt-up position to fully closed position, from fully open position to fully closed position) by operating the moonroof switch.

NOTE: Check the height of the sliding glass (page 20-49).
6. Close the sliding glass fully and check for water and air leaks. NOTE: Do not use high pressure water.