Quarter Glass
Removal
CAUTION:
• Wear gloves to remove and install the glass.
• Use seat covers to avoid damaging any surfaces.
1. To remove the quarter glass, first remove the:
• Rear seat (page 20-63)
. Rear pillar trim panel (page 20-58)
• Quarter trim panel (page 20-58)
2. Use a knife to cut through the glass adhesive from inside the car, all the way around.
Installation
1. Scrape the old adhesive smooth with a knife, to a thickness of about 2 mm (0.08 in) on the bonding surface around the entire window glass flange.
NOTE:
• Do not scrape down to the painted surface of the body: damaged paint will interfere with proper bonding.
• Remove all traces of the rubber spacer material from the body.
• Mask off surrounding surfaces before applying primer.
2. Clean the body bonding surface with a sponge dampened in alcohol.
NOTE: After cleaning, keep oil, grease or water from getting on the surface.
3. If the old glass is to be reinstalled, use a putty knife to scrape off all traces of old adhesive, then clean the glass surface with alcohol where new adhesive is to be applied.
NOTE: Make sure the bonding surface is kept free of water, oil and grease.