Rear Window
Removal
CAUTION:
• Wear gloves to remove and Install the glass.
• Do not damage the defroster grid lines.
1. To remove the rear glass, first remove:
• Trunk lid (page 20-80)
• Rear seat back (page 20-64)
• Rear shelf (page 20-59)
• Rear pillar trim panel (page 20-59)
2. Disconnect the defroster leads, and remove their holders.
NOTE: Avoid scratching or scoring the glass with the cutter blade.
3. Remove the clips, then remove the lower cover. NOTE: Use a clip remover to remove the clips.
4. Peel off the molding.
NOTE: When molding removal is difficult, cut the molding with a knife.
5. Pull down the rear of the headliner (page 20-57).
CAUTION: Take care not to bend the headliner excessively.
6. Apply protective tape along the edge of the body next to the glass as shown.
Using an awl, make a hole through the glass adhesive from inside the car. Push piano wire through the hole and wrap each end around a piece of wood.