Мануалы автомобилей Хонда

SRS Unit Precautions

Take extra care when painting or doing body work in the area below the dashboard. Avoid direct exposure of the SRS unit or wiring to heat guns, welding or spraying equipment.

Connect the short connectors before working below the dashboard near the SRS unit.

After any degree of frontal body damage, or after a collision without airbag deployment, inspect the SRS unit for physical damage. If it is dented, cracked, or deformed, replace it.

Be sure the SRS unit is installed securely.

During. installation or replacement, be careful not to bump (impact wrench, hammer, etc.) the area around the SRS unit. The airbags could accidentally deploy and cause damage or injuries.

Do not disassemble the SRS unit.

Store the SRS unit in a cool (less than about 40°C) and dry (less than 80% humidity, no moisture) place. Do not spill water or oil on the SRS unit, and keep it from dust.

Inspection After Deployment

After a collision in which the airbags were deployed, replace the SRS unit and inspect the following:

1. Inspect all the SRS wire harnesses. Replace, don't repair, any damaged harnesses.

2. Inspect the cable reel for heat damage. If there is any damage, replace the cable reel.

3. After the car is completely repaired, turn the ignition switch on. If the SRS indicator light comes on for about six seconds and then goes off, the SRS system is OK. If the indicator light does not function properly, go to SRS Troubleshooting.

SRS Unit Precautions

Inspection After Deployment

О компании

Каталоги

Каталоги авто

Информация