Airbag Assembly (SRS-Type III)

Replacement

After a collision in which the airbags were deployed, the airbag assemblies and the SRS unit must be replaced.

A WARNING Store a removed airbag assembly with the pad surface up, if the airbag is improperly stored face down, accidental deployment could propel the unit with enough force to cause serious injury.

CAUTION:

Do not install used SRS parts from another car. When repairing, use only new SRS parts.

Carefully inspect the airbag assembly before you install it. Do not install an airbag assembly that shows signs of being dropped or improperly handled, such as dents, cracks or deformation.

Always keep the short connectors (RED) on the airbags when the harness is disconnected.

Do not disassemble or tamper with the airbag assembly.

1. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least three minutes.

2. Connect the short connectors (RED) to the airbag side of the connectors:

Driver's Side:

Remove the access panel from the steering wheel, then remove the short connector (RED) from the panel.

Disconnect the 3-P connector between the driver's airbag and cable reel, then connect the short connector (RED) to the airbag side of the connector.

Front Passenger's Airbag:

Remove the glove box, then remove the short connector (RED) from its holder.

Disconnect the front passenger's airbag 3-P connector from the SRS main harness, and connect the short connector (RED) to the front passenger's airbag 3-P connector.

Airbag Assembly (SRS-Type III)

Replacement

О компании

Каталоги

Каталоги авто

Информация