ВНИМАНИЕ! График работы на майских праздниках: Офис в Москве: 9 мая ВЫХОДНОЙ! Офис в СПБ: 1 мая, 9 мая - ВЫХОДНОЙ!

Ignition Switch

Steering Lock Replacement

CAUTION:

All SRS wire harnesses are covered with yellow insulation.

Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.

Before disconnecting the SRS wire harness, turn the ignition switch OFF, disconnect the battery negative cable, then disconnect the positive cable, and wait at least three minutes.

Whenever the ignition switch is ON (11), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could accidentally deploy and cause damage or injuries.

Before you disconnect any part of an SRS wire harness, connect the short connectors (RED) to the airbags.

For additional precautions, refer to page 23-B6 in the SRS sub-section.

1. Disconnect both the negative cable and positive cable from the battery.

2. Remove the dashboard lower cover.

3. Disconnect the 5-P connector from the under-dash fuse/relay box, and disconnect the 7-P connector from the main wire harness.

4. Remove the steering column covers.

Ignition Switch

Steering Lock Replacement

О компании

Каталоги

Каталоги авто

Информация