ВНИМАНИЕ! График работы на майских праздниках: Офис в Москве: 9 мая ВЫХОДНОЙ! Офис в СПБ: 1 мая, 9 мая - ВЫХОДНОЙ!

Wipers/Washers

Windshield/Rear Intermittent Wiper Control Unit Input Test

CAUTION:

All SRS wire harnesses are covered with yellow insulation.

Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.

Before disconnecting the SRS wire harness, turn the ignition switch OFF, disconnect the battery negative cable, then disconnect the positive cable, and wait at least three minutes.

Whenever the ignition switch is ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could accidentally deploy and cause damage or injuries.

Before you disconnect any part of an SRS wire harness, connect the short connectors (RED) to the airbags.

For additional precautions, refer to page 23-B6 in the SRS sub-section.

1. Disconnect the 6-P and 4-P connectors from the control unit.

2. Inspect the connector and socket terminals to be sure they are all making good contact.

If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.

If the terminals look OK, make the following input tests at the connectors. - If any test indicates a problem, find and correct the cause, then recheck the system.

- If all the input tests prove OK, the control unit must be faulty; replace it.

Wipers/Washers

Windshield/Rear Intermittent Wiper Control Unit Input Test

О компании

Каталоги

Каталоги авто

Информация