Vehicle Speed Sensor (VSS)

Replacement

1. Disconnect the 3-P connector from the vehicle speed sensor (VSS).

2. Remove the mounting bolts, then remove the VSS.

3. Install in the reverse order of removal.

NOTE: The VSS drive link is a very small part; be careful not to lose it.

Engine Low Oil Pressure Indicator System

Engine Oil Pressure Switch Test

1. Remove the YEURED wire from the engine oil pressure switch.

2. Check for continuity between the positive terminal and the engine (ground) with the engine OFF.

3. Check for continuity again, this time with the engine running.

4. Make sure engine oil level is OK, then check engine oil pressure (see section 8).