ВНИМАНИЕ! График работы на майских праздниках: Офис в Москве: 9 мая ВЫХОДНОЙ! Офис в СПБ: 1 мая, 9 мая - ВЫХОДНОЙ!

Seats

Rear Seat Belt Replacement

CAUTION: Check the rear seat belts for damage, and replace them if necessary. Be careful not to damage them during removal and installation.

1. Remove:

Rear door sill molding (see page 20-57)

Trunk mat (see page 20-58)

Rear shelf and rear side shelf (see page 20-56)

Rear trim panel (seepage 20-58)

Rear seat-back (see page 20-66)

Trunk side panel (see page 20-58)

Rear seat side trim (see page 20-57)

2. Remove all the anchor bolts, the retractor bolt and the retractor mounting bolts, then remove the rear seat belts and center belts.

NOTE: When removing the anchor bolts and the retractor bolt, use a 17 mm socket or box-end wrench.

3. Check that the retractor locking mechanism functions as described on page 20-74.

4. Installation is the reverse of the removal procedure.

NOTE:

Make sure you assemble the washers and collars on the upper anchor bolt (see page 20-73).

Before attaching the rear pillar trim panel and rear seat side trim, make sure there are no twists or kinks in the rear seat belt.

Before attaching the seat-back, make sure there are no twists or kinks in the rear seat belts and center belts.